Capability
Thread rolling
Rolls the thread rather than cutting it, so material is displaced instead of removed.
Applied after or before heat treatment depending on the class and the geometry.
What we have written about it

Thread Go Gauge Disagreement
Two people measure the same screws with the same kind of gauge and reach opposite verdicts. Usually neither is lying.

UNF vs Metric Thread Interchange
A drawing says 1/4-28 UNF and the first question back is often "can we use M6 instead". The angle is the same, almost nothing else is.

Thread Rolling After Heat Treatment
Two fine-thread class 8.8 parts, two process routes. Threads rolled before heat treatment were nicked and stopped the go gauge; threads rolled after ran through.

Custom Threaded Rods One Mould Fee
A turned quote for four custom threaded rods came in too high. We re-quoted on cold heading, split the samples between the two processes, and all four parts moved into…
Parts of this kind
These are parts we have produced. Which process a given part goes through depends on its geometry and quantity — send the part and we will tell you which one yours needs.



